Stockmaster PSAL/PSADL

Specifications

LENGTH
Overall lengths range from 44'-0" to 53'-0".

WIDTH
Overall width is 102." Inside width is 99" between sides.

HEIGHT
11-0", 11'-6", 12'-0", 12'-6", 13'-0", and 13'-6" overall heights available. PSADL Drops available in 6", 8", or 12" at belly. All based on 49" F.W.H.

KING PIN
6" high assembly with top locking channel. Standard setting: 30" minimum setting: 27" PSADL maximum setting: 44". Pin settings deeper than 44" require belly to be shortened. NOTE: 10'-0" nose is standard.
PSAL has no maximum setting.

LANDING GEAR
Extruded aluminum telescoping support legs with safety spring lock pins for height adjustment.

FRONT
12" radius front corners with .080" aluminum single wall construction and extruded aluminum rib reinforcing channels, and a 6" aluminum lower front channel. Three-piece aluminum cap with spun corner caps.

SPARE TIRE CARRIER
Optional at extra cost.

SIDES
Formed, offset sheet and post side sections of .080" aluminum with two sides of punched and double-embossed oval openings. Extruded aluminum headers, deck rails, and rub rails. Formed posts on 21" centers.

CLEAN OUT DOOR
Optional at extra cost.

ACCESS DOOR
Optional at extra cost.

ROOF
One piece translucent roof skin bonded to extruded aluminum roof bows. Aluminum roof is optional.

FLOOR
.110 aluminum tread plate with 5 corrugations, supported by 6" high extruded aluminum crossbars.

REAR END
Left-hand roll-up with 36" opening, right-hand solid. Full-width rubber bumper, four vertical rubber bumpers, and a stirrup step for trailer access are standard.

DECKS
Optional at extra cost.

GATES
Optional at extra cost.

RAMPS
Optional at extra cost.

BULLBAR
Optional at extra cost.

MUDFLAPS
Black Ultra-Rubber, anti-spray type are standard.

LIGHTS
Front J560 7-way connector mounted in a nose box. Wiring harness is a ultra-blue sealed system. Tail lights are grommet mounted. Sealed LED. Midspan combination turn & clearance lights are grommet mounted sealed LED. Interior lights - 3 total. Exterior lights - 2 groups of 3 individual stop & turn tail lights with one group on each side of rear end. 2 groups of 2 oval, grommet mounted, sealed LED stop & turn lights with one group on each side of upper rear header. Rear I.D. & Marker lights are recessed grommet mounted LED clearance, marker, and license plate lights are standard.

SUSPENSION
CB2300 air ride, flange mount, bolt-on SAF Holland flange mounted to aluminum sub frame.

AXLES
Two: 5" round, 22,500 lbs. nominal rating each.

BRAKES
16-1/2" x 7" x 5/8" extended service air brakes, no dust shields. Mandatory FMVSS-121 braking system standard with automatic slack adjusters. ABS is standard equipment using a 2S - 1M system.

HUBS
Dura-Lite, steel with National oil seals, Axilok spindle nuts, and Sentinal hub caps.

DRUMS
Cast steel, outboard mount.

WHEELS
Eight 10-hole hub-piloted, steel disc, white.

TIRES
Eight, Bridgestone radials, PSAL: 11R-24.5 Bridgestone R196 radials. PSADL: size dependant on front drop specified.

FINISH
All steel components are treated with a primer and painted with gray synthetic enamel finish coat to retard rust. King Pin area is undercoated. All aluminum components are left natural.